Bay Networks Remote Annex Manual do Utilizador descarregar pdf (Página 7)

Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 7

5.3 Assigning a User

A user profile is assigned by going into the Users Menu and adding a new user. In Figure

3, I have shown a typical user. Setting the Return List Attributes you define the attributes

that are set back to the RAS following a authentication from the RAS. The Return list tells

the RAC that:

• Van Jacobson IP header compression is allowed

• IP address is to be assigned from BLOCK_1 - Block 1 contains a list of sequential IP

address that are allocated for use.

• The supported framed protocol is PPP.

• Port Limit - Setting the Port Limit to 2 allows MLPP to be performed on this connec-

tion with a bundle of 2 channels.

FIGURE 3. A Typical Dial In User

Since the RADIUS server will most likely be used to provide security for accessing the

Command Line Interface, an example is included for a typical user for CLI. In the case of

Figure 4 the user is CLI and no attributes should be included in the profile.

When a user accesses the RAC from either telnet or the console monitor the RAC will

request a authentication from the RADIUS server to insure the user is authorized. The pro-

file in Figure 4 will be tested and the results returned to the RAC. If the username and

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Sem comentários

Bay Networks Remote Annex Manual do Utilizador Página 7