Bay Networks 4000 Guia de Instalação Página 75
- Página / 162
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
3-3Remote Annex 4000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
Table 3-1. ROM Monitor Commands (continued)
(continued on next page)
Command Description Use
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash.
Upgrading or
replacing the Flash
image.
config Displays the current
hardware
configuration and
revision levels.
Identifying your
hardware, memory,
and ROM versions.
console-baud Changes the console
port’s baud rate.
Configuring the
console port for
remote maintenance.
erase Erases non-volatile
memory.
Loading a new image
and need to erase the
old image.
help Displays the list of
ROM Monitor
commands.
Referencing the ROM
monitor commands.
image [-d | <file>] Displays and/or sets
the load image and
tftp load dump
names.
Loading an image
that differs from the
default.
ipx [-d] Displays and sets
EEPROM values
relevant to Novell/
IPX network
addressing, including
the IPX load/dump
file server.
Changing Novell/IPX
configuration
parameters.
lat_key [-d] Sets the LAT key. Connecting to a DEC
VMS host.
- Remote Annex 1
- © 1996 Bay Networks, Inc 2
- Revision Level History 3
- Contents 5
- Contents 6
- Figures 10
- Tables 12
- About this Guide 13
- Printing Conventions 14
- Related Documents 15
- Bay Networks Customer Service 17
- World Wide Web 19
- Customer Service FTP 20
- Support Source CD 20
- CompuServe 20
- InfoFACTS 21
- How to Get Help 22
- Remote Network Access 23
- Dial-up Routing 24
- Chapter 1 Introduction 25
- Remote Annex 4000 Description 26
- Main Logic Board 26
- Serial Line Controllers 27
- Asynchronous SLC 28
- Firmware and Software 29
- Supported 30
- Configurations 30
- Watchdog Timer 30
- Front Panel 31
- Front Panel Components 32
- Rear Panel 33
- Rear Panel Components 34
- Mode Jumper 35
- Network Interface 35
- Connectors 35
- Physical Characteristics 36
- 6 in. (15 cm) 38
- Before you Begin 39
- Ethernet cable 41
- Ethernet cable (see 42
- Figure 2-3): 42
- Figure 2-4): 43
- Connecting a Console Terminal 45
- Cable Retainer 48
- PBX End 48
- PBX Screw 49
- Cable Retainer Screw 49
- 50–19,200 250 75 51
- 38,400 200 60 51
- 57,600 100 30 51
- 115,200 50 15 51
- Connecting a Parallel Printer 52
- Power Select Switch 53
- 2 Apply power 54
- 4000 to your LAN 57
- This section describes: 57
- Server. Proceed as follows: 58
- Remote Annex and press 59
- Prerequisites 61
- The system responds: 64
- For example: 65
- For example: 65
- Auto-initializing the ROMs 66
- BOOTP response with the sm 68
- 4 Boot the Annex 69
- Invoking the Console Monitor 70
- Command Descriptions 74
- Command Description Use 76
- (Flash) is installed 83
- Remote Annex 4000 is booted 86
- 4000 ROM Monitor commands 89
- Network test – PASSED 94
- [data bytes] [npackets] 97
- Interface sequence: sl2,net 102
- Prompt Description 104
- Statistic Description 105
- Power-up and Boot Procedures 108
- On continuously 109
- Flashing irregularly 109
- Test Mode Diagnostics 113
- Table 4-4 115
- Boot Failures 117
- Boot Error Report 118
- Error Description 119
- # /etc/erpcd –D5 123
- # boot -v 123
- Another Remote Annex 4000 124
- VAX VMS Load Host on the LAN 125
- ● ● ● ● ● 126
- Console Port 129
- Coaxial Center 130
- Conductor 130
- Coaxial Shield 130
- 10Base5 Ethernet Port 131
- 10BaseT Ethernet Port 132
- Serial Port 133
- Pin Signal Pin Signal 134
- Parallel Printer Port 135
- Serial Port Cables 137
- Remote Annex 4000 Champs 138
- (continued on next page) 139
- Serial Cable Wiring Diagrams 143
- Printer Cables 145
- Dataproducts 146
- Printer Cable 146
- Loopback Connectors 147
- PBX Loopback 148
- Connector 148
- Contents of the Kit 149
- Dress Panel Cover 150
- (10 Places) 151
- (4 Places) 152
- Figure C-6) 153
- Assembly Instructions 155
- Power-up and Test 156
- Test Button 157
- PBX Loopback Plug 158
- Numerics 159
- Index 160
Manuais e produtos relacionados com Software Bay Networks 4000
Software Bay Networks FastLink II Especificações
(47 páginas)
(47 páginas)
Software Bay Networks Radius Manual do Utilizador
(96 páginas)
(96 páginas)
Software Bay Networks BayRS Manual de Serviço
(18 páginas)
(18 páginas)
Software Bay Networks Radius Manual do Utilizador
(14 páginas)
(14 páginas)
Software Bay Networks ATMSpeed Especificações
(74 páginas)
(74 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais