Bay Networks 5000 Manual de Serviço Página 99
- Página / 166
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Configuring the ARN for Netboot and Directed Netboot
114200-D Rev 00
A-3
Table A-1 describes the ifconfig command settings for configuring a COM
interface.
Table A-1. COM Interface ifconfig Command Settings
Setting Description
Default Setting
-d
Resets the router IP interface settings to the default values. This
setting tries four WAN configurations in the following order until it finds
the correct type for the router connection to the network:
1. Bay Networks HDLC encapsulation (also referred to as
Bay Networks Standard Point-to-Point) with external clocking
2. Frame Relay Annex D
3. Frame Relay LMI
4. Frame Relay Annex A
56/64K CSU/DSU Settings
-r
Configures 56/64K telco service for 56K DDS or 64K Clear Channel.
Use one of the following options:
56
or
64
.
Frame Relay Settings
-fr
Configures the router COM interface as a frame relay connection.
With this setting, use one of the following options to specify a DLCMI
setting:
-annexd
,
-annexa
, or
-lmi
.
-annexd
-annexa
-lmi
When one of these options is used with the
-fr
setting, it specifies a
DLCMI setting. Use the same setting as the network to which the
router’s frame relay interface is connected. The default setting for
frame relay is
-annexd
.
Internal Clocking Setting
-int_clk
Sets the serial interface to internal clocking at 1.25 MB/s. If you do not
specify this setting, the router defaults to external clocking.
IP Connector Setting
<interface>
Specifies the IP connector you are configuring. Use the format
com
<
port #
>.
IP Address Settings
<IP_address>
Specifies the IP address of the interface you set with
<interface>
.
Provide this address in dotted decimal notation.
(continued)
- Installing and Operating 1
- BayStack ARN Routers 1
- Trademarks 2
- Statement of Conditions 2
- USA Requirements Only 3
- European Requirements Only 3
- Taiwan Requirements 4
- Canada Requirements Only 4
- Contents 7
- 114200-D Rev 00 10
- Before You Begin 17
- Text Conventions 18
- Acronyms 19
- How to Get Help 22
- Chapter 1 23
- Installing the ARN 23
- Preparing to Install the ARN 24
- Additional Equipment 26
- Rack-Mounting the ARN 28
- Caution: 33
- and Figure 1-7 34
- ARN0066A 39
- ARN0064A 40
- Digital line 41
- Reg. Number 4P8USA-31445-DE-N 42
- ARN0090B 43
- RJ-11 telephone 44
- DB-60 cable 46
- DB-25 connector ports 46
- Connecting a PC Console 47
- Connecting a Terminal Console 49
- Console cable plus 50
- Connecting a Console Modem 51
- Connecting the Power Cable 54
- Console Modem 55
- Redundant Power 55
- Where to Go Next 56
- Chapter 2 57
- Starting the ARN 57
- Using EZ-Install 61
- Interrupting the Boot Process 62
- Continuing with Netboot 64
- $) appears 70
- Chapter 3 73
- Operating the ARN 73
- Base Module LEDs 74
- Ethernet 10BASE-T LEDs 75
- Table 3-2 75
- Expansion Module LEDs 77
- Adapter Module LEDs 78
- Table 3-10. ISDN BRI LEDs 79
- Table 3-13. X.25 PAD LEDs 80
- Table 3-14. V.34 Modem LEDs 81
- Table 3-15. Boot Status LEDs 82
- Protecting Memory Card Files 86
- Chapter 4 89
- Powering Down 90
- Removing the Filler Panel 91
- Metal tab on filler panel 92
- Removing an Adapter Module 93
- Installing an Adapter Module 94
- What to Do Next 96
- Appendix A 97
- Directed Netboot 97
- Using the ifconfig Command 98
- <IP_address> 99
- <interface> 99
- <interface> 100
- <next_hop_address> 100
- Examples of ifconfig Commands 102
- Using the bconfig Command 103
- Verifying Your Configuration 104
- Appendix B 107
- Before You Run Quick-Start 108
- Quick-Start procedure 109
- Filling Out the Worksheets 110
- Global Information Worksheet 111
- Router Protocol Worksheets 114
- OSPF Worksheet 115
- RIP Worksheet 115
- Wide Area Protocol Worksheets 118
- Frame Relay Worksheet 119
- PPP Standard Worksheet 120
- Appendix C 125
- ARN Technical Specifications 125
- Electrical Specifications 126
- Environmental Specifications 126
- (continued) 128
- CAB0107A 130
- Table C-4 131
- Token Ring STP Interface 132
- Token Ring UTP Interface 133
- Serial Interfaces 133
- Table C-7 134
- ISDN BRI U Interface 135
- ISDN BRI S/T Interface 136
- 56/64K DSU/CSU Interface 137
- FT1/T1 DSU/CSU Connections 137
- 12345678 138
- X.25 PAD Connections 139
- Local Console Connections 140
- Service Modem Connections 141
- Appendix D 143
- CAB0069B 146
- CAB0073A 147
- (continued) 149
- CAB0068A 152
- CAB0074A 153
- P6 Host port SELV 154
- Adapter Modules 156
Manuais e produtos relacionados com Software Bay Networks 5000
Software Bay Networks 5391 Manual de Serviço
(20 páginas)
(20 páginas)
Software Bay Networks Event Manager Especificações
(73 páginas)
(73 páginas)
Software Bay Networks Baystream 7 Manual de Serviço
(382 páginas)
(382 páginas)
Software Bay Networks BayRS Manual do Utilizador
(24 páginas)
(24 páginas)
Software Bay Networks 5000 Especificações
(185 páginas)
(185 páginas)
Software Bay Networks BayRS Manual do Utilizador
(16 páginas)
(16 páginas)
Software Bay Networks Baystream 7 Guia do Utilizador
(162 páginas)
(162 páginas)
Software Bay Networks 4000 Guia de Instalação
(162 páginas)
(162 páginas)
Software Bay Networks FastLink II Especificações
(47 páginas)
(47 páginas)
Software Bay Networks Radius Manual do Utilizador
(96 páginas)
(96 páginas)
Software Bay Networks BayRS Manual de Serviço
(18 páginas)
(18 páginas)
Software Bay Networks Radius Manual do Utilizador
(14 páginas)
(14 páginas)
Software Bay Networks ATMSpeed Especificações
(74 páginas)
(74 páginas)
Deltaco Téléphones mobiles manuels d'utilisation
À partir de T
Comentários a estes Manuais