Bay Networks 5391 Guia de Instalação descarregar pdf (Página 72)

Remote Annex 6300 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

3-14

console-baud

The console-baud command changes the console port’s baud rate.

Thus, the console port can interface with any modem to which it is

connected. When the baud rate is entered as auto, the Remote Annex

6300 detects the baud rate of the incoming line and adjusts its baud

rate accordingly. This command provides support for remote

troubleshooting. The command syntax is:

console-baud

The command display looks like this:

This command has no effect on the port’s baud rate after the

Remote Annex 6300 is booted.

monitor:: console-baud

Remote Diagnostic Test Mode

In order to use the remote diagnostic functionality, you

must first connect a modem to the console port of the

Annex. The modem should be configured such that DTR is

forced on, carrier detect and DSR are set normal, and

auto-answer is enabled. Once this is done, contact your

service representative for remote diagnostic maintenance.

To enter “Autobaud Mode”, please type “Auto”. To

“manually” configure the Annex console port, please type

in the desired baud rate. To return to the “monitor::”

prompt strike the “carriage return <CR>” key.

[Baudrate Range: 50–9600 BAUD]

Select Baudrate []:

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 137 138

Sem comentários

Bay Networks 5391 Guia de Instalação Página 72