Bay Networks Remote Annex Guia de Instalação descarregar pdf (Página 113)

4-21

Chapter 4 Troubleshooting Procedures

Nortel Networks 5399 Access Switch Hardware Installation Guide

Removing a Module

To remove a Remote Access Concentrator, follow these steps:

1. Using the flat-tip screwdriver, loosen the two captive

retaining screws on the module until they pop free of the

chassis.

2. Push the top and bottom inserter/extractor levers away

from the center of the Remote Access Concentrator front

panel to release the module from the backplane connector.

3. Slide the module out of the chassis.

Grip the front panel with one hand while supporting the bottom

of the module with the other hand.

4. Place the module on an antistatic mat.

If a module is removed from the chassis permanently or for more than a

few minutes, you should install a filler panel on the empty chassis slots

to maintain the cooling air flow within the chassis.

The removed Remote Access Concentrator retains all of its set

parameters, including the IP address. If you reuse this module

elsewhere without removing this IP address, you will have

duplicate IP addresses on your network.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 125 126

Sem comentários

Bay Networks Remote Annex Guia de Instalação Página 113