Bay Networks 5391 Guia de Instalação descarregar pdf (Página 74)

Remote Annex 2000 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

3-16

erase

The erase command erases the contents of non-volatile memory,

including the Remote Annex 2000’s IP address. This command also

restores the parameters to their factory defaults. The syntax is:

erase

If the self-boot option is installed, the erase command prompts for

which non-volatile memory to erase: EEPROM or FLASH. Entering

1 at the prompt causes the Remote Annex 2000 to erase the EEPROM

memory (configuration information); entering 2 at the prompt causes

the Remote Annex 2000 to erase the Flash memory (self-boot image).

The erase command does not erase the Ethernet address.

Since the erase command erases the IP address, you must use

the addr command to re-enter the Remote Annex 2000’s IP

address before reloading any software.

The erase command display looks like this:

If the self-boot option is not installed, the command display looks

like this:

monitor:: erase

1) EEPROM (i.e. Configuration information)

2) FLASH (i.e. Self boot image)

Enter 1 or 2:: 1

Erase all non-volatile EEPROM memory? (y/n) [n]:: n

monitor:: erase

Erase all non-volatile EEPROM memory? (y/n) [n]:: n

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 135 136

Sem comentários

Bay Networks 5391 Guia de Instalação Página 74