Bay Networks 5391 Guia de Instalação descarregar pdf (Página 90)

Remote Annex 2000 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

3-32

Table 3-2. The slip Command Prompts (continued)

Prompt Description

Enter remote

endpoint address

Speciﬁes the IP address of the remote end of the

SLIP interface.

Enter remote load/

dump host address

Speciﬁes the IP address of the remote host to

which load and dump requests are sent. This

address is required only if the remote host is a

gateway and not the load host. By default, this is

the same as the remote end-point address.

Should this interface

be used for memory

dumps

Enables the Remote Annex 2000 to use a SLIP

interface for memory dumps. The default is y.

Enter the baud rate Speciﬁes the baud rate of the serial interface. The

default is 9600.

Enter the number of

stop bits

Pressing the key accepts the default (one).

Generally, SLIP implementations require

the default.

Enter the parity

Pressing the key accepts the default

(none). Generally, SLIP implementations require

the default.

Return

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 135 136

Sem comentários

Bay Networks 5391 Guia de Instalação Página 90