Bay Networks Remote Annex Manual do Utilizador descarregar pdf (Página 26)

Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 26

In order to monitor the syslog messages on the console terminal the user will need to be

logged out of CLI and the RAC must be in the default state for “annex syslog”. See figure

15 for the view of the syslog parameters.

FIGURE 15. Syslog Event Logging

If you choose logs can be sent to a external logging device. The event logs can be sent to a

Unix 4.3 BSD syslog daemon or the can be sent to a Windows NT server running the Bay

“Annex syslogd” services. Either syslog daemon are set up the same on the RAC.

Setup is simple, the parameters which control the syslog are in the annex syslog menu.

Figure 15 gives an overview of the parameters. The syslog_host IP address must be set to

the device doing the recording. The syslog_facility can likely be left to the default.

syslog_mask should be set to the minimum level of your requirements. Initially debug

might be your choice, but with the quantity of messages that are generated the buffers in

the syslogd device can easily be overflowed.

Table 4 shows the priority levels “high “emergency to low “debug”. When a priority has

been chosen that level plus all higher levels will be reported to the syslogd host.

TABLE 4. Priority Levels for the syslog_mask Parameter

Level Name Description

High emergency Hardware failures.

alert All RAC reboots.

Note

If you are in the console monitor in CLI and you want to view

syslog messages, type “ha” (hangup). This will allow console messages

to be outputted to the console, if no syslog host has been set.

admin : show annex syslog

syslog_mask:*alert,critical,debug,emergency,error,info,notice,warning

syslog_facility: log_local7 syslog_host:*47.39.240.99

syslog_port: 0

This parameter message priority level to be reported. In this exapple

debug was set so all levels will be set. Default none

This is the IP address of the logging host. It can be a Windows NT host

running Bay software or a UNIX device running syslogd.Default 0.0.0.0

This sets the syslog facility. Valid options are log_local0 through

log_local7. Log_local7 is the default..

This value is always 0 and is not supported on the RAC8000.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Sem comentários

Bay Networks Remote Annex Manual do Utilizador Página 26